Graphite Sheet Reinforced with (0.2mm) Glued SUS316 Mesh Insert, 10-PACK

Description

Graphite Sheet Reinforced with (0.2mm) Glued SUS316 Mesh Insert
SIZE: 13"X10"x1/16" Thick
10 sheets per package
Why Graphite?
Graphite has several advantages over other materials. It is resistant to thermal shock. It is the only material in which mechanical properties increase with temperature. It has a low CTE for geometrical stability. It is easily machined. It does not melt but sublimes at very high temperature (3,400ºC), and finally, its density is lower (five times less than copper) which means lighter electrodes. Graphite removes material better than copper or copper-tungsten while wearing slower. The wear rate tends to diminish as the discharge increases, unlike copper, whose wear increases at higher currents. Therefore, graphite is suited for the machining of large electrodes since working with a high current intensity provides decreased roughing time.
Although graphite is prone to abnormal discharge, this can be eliminated through quality flushing, and lowering the intensity of discharge during negative polarity machining. However, as a result of this tradeoff, machining tungsten carbides is more difficult than with copper-tungsten electrodes. Also, since graphite is a ceramic, it is sensitive to mechanical shock, and consequently must be handled and machined with care.
-Mersen
ADVANTAGES
– Asbestos-free
– No respirable fibers
– No health hazard
– No aging or embrittlement
– Non-toxic and suitable for foodstuffs and potable water
– Low chloride content
– Excellent creep resistance with no hot or cold flow
– Excellent gas and fluids impermeability
APPLICATIONS
– Elevated service pressure and gasket stresses
– Heat transfer oils
– Cylinder gaskets
– Reinforced sealing gaskets spacers
– Pipework and vessel in the petro-chemical industries and power stations
– Tongue-and-groove
– Pumps and fittings
– Unstable flanges with low gasket stresses